This is the installation for the Pace PVR2. However please follow these instructions for all boxes first then check with the make of your box for addition infomation.
This is what the inside of the Pace PVR2 looks like.
This is the fan controller. There are only 3 connections. The main board was made to fit in the rails at the rear of the box. The fit is tight but it does fit. Place one side of the rail first then gently spread the other and the controller will slip into place.
Place on one side of the rail first then spread the other side and it will slip into place.
This is the controller in the correct position. Next is to connect the cables
First is the power connector. At the back of the hard drive there is a connector like this. (hard drive has been lifted out for a better image)
Next we need to remove power connector from the hard drive. It is easier to remove the 4 screws and lift the hard drive out.
Remove the hard drive power connector.
Next plug in the new connector between the main board and the hard drive. This will power the controller and the fan.
Now plug the other end of the cable into the hard drive.
Now put the hard drive back in place and locate the piece of wire supplied to hold the sensor in position under the hard drive screw.
Now lets deal with the fan. First is to unplug the fan connector from the main board.
NOTE: This socket will NOT be used again.
Plug the new connector marked "A" into this fan connector. Make sure that the red mark corresponds to the red wire.
(fan has been removed for a better image)
This is the connector pushed fully home.
And finally this is what your completed installation will look like. Now you must TEST your installation. Click here to
TEST YOUR INSTALLATION